Rubi Delta Leveling System clips are designed to ensure the best leveling and positioning of tile during installation. The plastic clips work with the leveling system wedges to establish a rigid grout line while also creating a level tile surface.
1/16" (1 mm) grout joint line
For use with 1/8" (3 mm) - 1/2" (12 mm) thick tile
Available in 100, 200, 400 and 2,400 piece bags/boxes
Ideal for installing large format tiles (minimum tile size - 12" x 12") with the back buttering method
Clips easily removed after adhesive has cured by either kicking the clip/wedge out of the grout line or using a mallet
Designed to prevent movement of tile and adhesive while the adhesive is setting for an ideal surface flatness
Saves time and money during tile installation
How to Install Tile with the Delta Leveling System
Step 1: Spread your tile adhesive and lay the tile. Place Rubi Delta clips underneath the tile slightly back from the edge. Keep the clip firm against the tile as the clip acts as a spacer
Step 2: Set the adjacent tile firmly into the adhesive. Butt the tile against the Delta clip giving the 1/16" joint (if a larger joint is required spacers can be used, or set the required joint size). Slide the Delta wedges through the clips until they are firmly leveling both tiles
Step 3: Using your thumb, push the Delta wedge with the right amount of pressure required to create the perfect finish. If you need more pressure on the tile, use the Delta Leveling Pliers. Once the tiles are locked in position this is how they will stay until the adhesive sets. You can still slightly adjust the joint width while the adhesive is setting if needed without disrupting the height of the tiles
Step 4: After the adhesive has set, you can remove the wedges and clips easily with a rubber mallet on the walls and by mallet or your foot on the floor. Hit the clip on its side in the direction of the tile joint and the wedge and clip will dislodge from the tile at the breakpoint below the tile, leaving the joint free for grouting or silicone expansion
The clips of the delta tile leveling system are available in different thicknesses, to allow installation in joints of 1/32 In., 1/16 In., and 1/8 In., as well as at various heights, to work with tiles of various thicknesses: 1/8 In. to 1/2 In., 1/4 In. to 9/16 In. or 7/16 In. to 13/16 In.
The clips of the delta system allow installers to work with any type of tile spacer, and thereby ensure the best leveling and positioning of tiles
The design of the delta tile leveling clips combined with the technical plastic material they are made of, ensure that whenever the leveling pressure is exerted, only the highest piece is lowered, avoiding the creation of air bubbles in the adhesive
Ideal for laying large format tiles
Minimum size required: 12 In. x 12 In.
The design of the delta tile leveling system strips allows them to be removed by impact (kick or mallet). Removal by impact should always be in the direction of the grout joint.
The delta tile leveling system prevents the movement of parts when the adhesive is setting and improves the resulting surface flatness
Thanks to the delta tile leveling system, the tile installer sees how work time is reduced and the profitability of installation work improves, avoiding leveling errors that occur during mortar drying